My Noxy has been wearing through at the grip. Well, since I have a little bit of time to kill it was time address it with an idea that came to me months ago. I had saved one of my punctured bicycle inner tubes to make a grip for it. First you cut your inner tube down the entire length. Then you cut it into a long strip about 1¼ - 1½ wide. I started by the back firmly winding it around like a tennis racket handle. At the front, near the control box, I tapered the end, trimmed it and then used some orange electrical tape that I like to use to secure it in place. Voila! New & improved grip! It feels really good and I’m pretty sure it’s going to work great. I might even go this route when the foam grip on my Excal wears out.