BARRACUDA METAL DETECTOR REPAIR

CudaPi

Junior Member
Joined
May 8, 2024
Messages
44
I have three Anchor Electronics Barracuda PI machines. Two of my coil connectors broke, the pins snapped, and my third coil the ring that screws the connect to the machine cracked, so I only have one good coil left. I have 2 8" and 2 12" I am looking if someone can repair these coil connectors and or hard wire the coils to the machines. Any help will be greatly appreciated if you sell connectors or know were I can get them.
Thank you,
CudaPI
 

Attachments

  • pin connector1.jpg
    pin connector1.jpg
    26.6 KB · Views: 253
  • pinconnector 2.jpg
    pinconnector 2.jpg
    24.1 KB · Views: 255
  • side connector.jpg
    side connector.jpg
    28.6 KB · Views: 235
  • unit connector.jpg
    unit connector.jpg
    101.9 KB · Views: 253
  • Metal Dectors.jpg
    Metal Dectors.jpg
    182.6 KB · Views: 244
Hi,I just got a Barracuda pi machine with the 8 inch coil in working condition .I was hoping that you could help me with a question what is the on and off switch for that is behind the front cover plate, I know that the machine is running 12 volts. Have been trying - to find someone that uses Barracuda .Sorry that I don't know anyone that can help you with repairing your units, I have a couple of detectors also that company's are gone and do most of the repairs myself. If you have any 12 inch coils extra would like to buy one . Thanks for any help .
 
I have no coils for sale. I found a person that is doing all the repairs. There are only two knobs on the face of the Barracuda that control the detector's operation. The knob in the upper left corner performs two functions: it turns the detector on and adjusts the detector's sensitivity as well as the audio threshold heard through the waterproof headphones. The knob in the lower left corner controls the pulse delay circuit, which provides a form of discrimination similar to that found on some of the other pulse detectors currently available. See the archived website it has information.
Hope this helps! Congrats on getting the machine.
 
Thank you , someone must of install a on and off switch on back side of face plate not sure why . I know that these detectors are hard to come by I got lucky and got this detector through Steve at REBEL detectors. If possible I would like to make contact with person that is doing repairs. THANK YOU VERY MUCH.
 
Back
Top Bottom