fsa46
Forum Supporter
I use these male connectors to protect the connectors on all my coils when not in use. These are for use on the Sovereign GT but would probably work on many of the detectors with a 6 pin fitting. You would have to check it out to confirm it would work on your machine.
I used a Philmore P/N 61-636, 6 pin , male, in-line connector. If I would have did a little more searching I could have used the Philmore P/N 61-626 Chassis Male connector, which is half the size and half the cost.
However, by using the in-line I was able to put a lanyard on each connector, ( as seen in the picture ) and they can stay with the coil even when in use.