When pinpointing The volume is very low to start off.
After I hit the pinpoint button I have to wait a few seconds for the volume to increase and
then I can pinpoint. While waiting I swing the coil over the target until the volume increases.
Its pretty frustrating......
Yes, I have the most recent firmware version and I have done factory reset.
This seems to have coincided with installing the 6" coil and then putting the stock coil back on. This is happening with the the 11" coil.
Did not do this before I tried out the 6" coil.
After I hit the pinpoint button I have to wait a few seconds for the volume to increase and
then I can pinpoint. While waiting I swing the coil over the target until the volume increases.
Its pretty frustrating......
Yes, I have the most recent firmware version and I have done factory reset.
This seems to have coincided with installing the 6" coil and then putting the stock coil back on. This is happening with the the 11" coil.
Did not do this before I tried out the 6" coil.