JunkInTheTrunk
Elite Member
I was bored last night and couldn't sleep. PLUS, I needed to get ready for work the next morning. Okay, I hope you guys don't get mad at me for doing this This is my version of doing it. I'm eventually going to put on two slide switches in place of the jumbper blocks. IF you guys want to see the "end result" with the slide switches then I will post that part. Other than that... I used a small cell phone vibrator motor, but NOT knowing exactly what voltage to put across it. So I hooked it to my power supply and started turning the knob and watching the current draw. It SEEMED to run smooth at around 2V @ 0.16mA. I'm THINKING about POSSIBLY bumping it up to 3V??? The mounting holes for R14 on a fresh 9V battery gave close to 8.8V so I just rounded up to 9V and calculated roughly 43 ohms. There is NO "43 ohm" resistor so you have to either use a 39 ohm OR a 47 ohm. I used the 47 ohm because that is what I had available. Anyways, gotta get going to work, but... again... I hope you guys/gals don't get mad for me posting this... "my" version??? HH \_
btw, let me know if you want to see the slide switch mods??? THAT'S IF you guys don't complain to the mods in telling them to delete this post
btw, let me know if you want to see the slide switch mods??? THAT'S IF you guys don't complain to the mods in telling them to delete this post