Saltshaker
Forum Supporter
Thought I would post this here in case anyone was interested:
The head unit was removed and fitted into a custom 3/4" Plexiglas frame. Then the front and back were made by vacuum forming plastic from custom molds. The front plastic cover is flexible which allows me to still use the buttons. It was mounted to an "S" shaft with a custom grip, battery pod (3 cell lipo in a waterproof tube), custom stand, waterproof headphone jack and an arm cuff made by Plugger. The original Minelab upper and lower shafts were used with a "splice" tube mounted below which allows me to change coils and currently has an 8x6 SEF coil attached. Hope you like it.
The head unit was removed and fitted into a custom 3/4" Plexiglas frame. Then the front and back were made by vacuum forming plastic from custom molds. The front plastic cover is flexible which allows me to still use the buttons. It was mounted to an "S" shaft with a custom grip, battery pod (3 cell lipo in a waterproof tube), custom stand, waterproof headphone jack and an arm cuff made by Plugger. The original Minelab upper and lower shafts were used with a "splice" tube mounted below which allows me to change coils and currently has an 8x6 SEF coil attached. Hope you like it.