Digger-Dave
Forum Supporter
I finally got around to doing this.
The $1.39 insurance policy.
I sheared my control box off in 2015. I was being too rough on it while pushing through thick brush. I learned!!
After a trip to Garretts and like $180 later the machine was like new again.
These 3/4" pipe hangers cost me 69 cents each.
You will need to drill two 5/32 holes about 1 1/2" apart about the center of the bend.
Then cut down the length of the hangers so they don't get in the way of either the coil or headphone wires. Break sharp edges too.
I believe these screws fasten the speaker and still have plenty of engagement.
The $1.39 insurance policy.
I sheared my control box off in 2015. I was being too rough on it while pushing through thick brush. I learned!!
After a trip to Garretts and like $180 later the machine was like new again.
These 3/4" pipe hangers cost me 69 cents each.
You will need to drill two 5/32 holes about 1 1/2" apart about the center of the bend.
Then cut down the length of the hangers so they don't get in the way of either the coil or headphone wires. Break sharp edges too.
I believe these screws fasten the speaker and still have plenty of engagement.