upena
Forum Supporter
And, donation made.
Thanks
Thanks
ok guys mailed out some decals
after removing old decal clean with alcohol to remove any remaining glue.
use rubbing alcohol not your good bourbon
sent to these cities
Miami
Bristol
Warren
Englewood
Aptos
Severna
Khon Kaen
if your not listed send me a message
Something like this But this is a small picture I edited, would love the original size or vector
View attachment 378015
Many thanks!ok guys mailed out some decals
after removing old decal clean with alcohol to remove any remaining glue.
use rubbing alcohol not your good bourbon
sent to these cities
Miami
Bristol
Warren
Englewood
Aptos
Severna
Khon Kaen
if your not listed send me a message
ok guys mailed out some decals
after removing old decal clean with alcohol to remove any remaining glue.
use rubbing alcohol not your good bourbon
sent to these cities
Miami
Bristol
Warren
Englewood
Aptos
Severna
Khon Kaen
if your not listed send me a message
Thanks again @sexton for the decals. I am now an Excalibur 1000 pirate. Here are some before and after photos of the Excal blue that I got used from Australia.
Thanks again @sexton for the decals. I am now an Excalibur 1000 pirate. Here are some before and after photos of the Excal blue that I got used from Australia.
I got the battery pod done but not the tube. How hard is it to remove the knobs?
Boy that will take all day with 6 knobs, I recommend WD 40 then hit them with the Air tools..much faster and cleaner.take a large pry bar and they should come off.
if you have stock knobs remove yellow cap you will see a nut that needs loosed up. I would plan on replacing them
I replaced my knobs with Andersons.
Boy that will take all day with 6 knobs, I recommend WD 40 then hit them with the Air tools..much faster and cleaner.
Clue me in on how these decals are made. In addition to making one for my excal II I'm wondering how they would do on Eurorack synthesizer panels.
Do they scratch easily?
Clue me in on how these decals are made. In addition to making one for my excal II I'm wondering how they would do on Eurorack synthesizer panels.
Do they scratch easily?