RayK
Senior Member
For background, I am coming from CZ6a to the T2 Classic model.
When looking at the screen on the T2,there is arrow above the target indicator, the manual says that the arrows indicated signal strength. Is this a factor of depth or is it more an indication of conductivity? I am trying to get a feel of the sound of the target in relation to these arrows.
The CZ6a was a three tone unit. The T2 has the same 3 tone option, I see a lot of people run 2+ tone. I have tried it a little but not real sure if it has any benefit over the 3 tone. Why do so many people recommend this setting?
Have not tried the delta pitch yet, I feel I need a lot more time with this detector but for trying this option. For people who use this mode, do you always use it or only for certain type of sites?
Thanks
Ray
When looking at the screen on the T2,there is arrow above the target indicator, the manual says that the arrows indicated signal strength. Is this a factor of depth or is it more an indication of conductivity? I am trying to get a feel of the sound of the target in relation to these arrows.
The CZ6a was a three tone unit. The T2 has the same 3 tone option, I see a lot of people run 2+ tone. I have tried it a little but not real sure if it has any benefit over the 3 tone. Why do so many people recommend this setting?
Have not tried the delta pitch yet, I feel I need a lot more time with this detector but for trying this option. For people who use this mode, do you always use it or only for certain type of sites?
Thanks
Ray