NCtoad
Forum Supporter
I usually only use the pinpoint for sizing or to check for ferrous if it doesn't pinpoint in the same spot as the signal. Mine does it too, but it never bothered me. It usually goes loud after a few sweeps.
Are you all pressing the pinpoint button when your coil is away from the target? Don't have the Nox, but have the Xterra 705, and you must press the button with the coil away from the target or it will exhibit some of the same behaviour. Don't know if this is the same for the Nox. Good luck.
When pinpointing The volume is very low to start off.
After I hit the pinpoint button I have to wait a few seconds for the volume to increase and
then I can pinpoint. While waiting I swing the coil over the target until the volume increases.
Its pretty frustrating......
Yes, I have the most recent firmware version and I have done factory reset.
This seems to have coincided with installing the 6" coil and then putting the stock coil back on. This is happening with the the 11" coil.
Did not do this before I tried out the 6" coil.