Friendly Metal Detecting Forums   River Team 6 Metal Detectors
List all sponsors

Go Back   Friendly Metal Detecting Forums > Detectors and Gear > How to Use Your Metal Detector

Reply
  
Thread Tools Display Modes
  #1  
Old 09-28-2020, 12:03 PM
fieldho fieldho is offline
New Member
 
Join Date: Aug 2020
Location: South Central Mississippi
Posts: 16
Default Anfibio vs nickels

I've been using an Anfibio Multi for about 2 months. I thought it just didn't like nickels, no problem with other coins. The problem lies in the numbers, I get the same 31 for nickels as I get for square pull tabs.
Has anyone found a work around for this? I haven't been able to find a work around for nickels. Has anyone found a trick to help reduce digging pulls. Up until now, I just ignore the signal but 31 is in a critical zone and I hate to ignore it.
Reply With Quote


  #2  
Old 09-28-2020, 05:01 PM
Stiffwrists Stiffwrists is offline
Elite Member
 
Join Date: Sep 2017
Location: Utah
Posts: 3,077
Default

Originally Posted by fieldho View post
I've been using an Anfibio Multi for about 2 months. I thought it just didn't like nickels, no problem with other coins. The problem lies in the numbers, I get the same 31 for nickels as I get for square pull tabs.
Has anyone found a work around for this? I haven't been able to find a work around for nickels. Has anyone found a trick to help reduce digging pulls. Up until now, I just ignore the signal but 31 is in a critical zone and I hate to ignore it.
With any machine, if you want to dig nickels, you're going to dig some pull tabs. I like old nickels, so i dig nickel signals if they are deep. I rarely dig shallow nickel signals unless there is a "good" probability of a gold ring. Otherwise, I walk over them. Some sites that I have pounded hard and all the high tones are few, I will start to dig them. There are a lot of nickels out there. Just depends on if the time wasted digging aluminum is worth it to you. I will tell you that one of these does make up for a lot of aluminum digging!
Attached Images
 

__________________
Equinox 800, AT MAX, ACE 350, Garrett Carrot, Lesche Excalibur Shovels
Totals Since June 2017:
Silver Coins: 279, Ag Rings/etc: 95
IH: 28, Buff/V/Shield: 45, Gold: 9

Reply With Quote


  #3  
Old 09-28-2020, 05:45 PM
Sven's Avatar
Sven Sven is offline
Elite Member
 
Join Date: Aug 2009
Location: Ontario, Canada
Posts: 679
Default

I always dig pulltabs, not that I like to, which is also the nickel range and gold ring range.
Attached Images
 

__________________
Putting fun back into Treasure Hunting.
Cruz'in with the Nokta/Makro Simplex for 2020.

Metal Detector Downloads, Catalogs, Tips and How-to's visit----- http://treasurelinx.com/

Reply With Quote


  #4  
Old 09-28-2020, 09:16 PM
fieldho fieldho is offline
New Member
 
Join Date: Aug 2020
Location: South Central Mississippi
Posts: 16
Default

Got it, I need to dig more tabs, ha, thanks!
Reply With Quote


  #5  
Old 10-03-2020, 08:13 PM
Akb82317's Avatar
Akb82317 Akb82317 is offline
New Member
 
Join Date: Aug 2020
Posts: 3
Default

I have found when you find a target and the vdi is showing nickel range, you can sometimes hear the difference if you wiggle the coil slowly towards you go back over it and turn 90 degrees. You want to hear that distinct coin tone the anfibio is throwing out. Like many others have stated. I always dig pull tabs if you want the jewelry and nickels thereís really no cheat code work around. The anfibio is a fantastic detector, the learning curve on multiple settings is pretty steep though. Depending on what your running, 3,4,5 tone I usually would change the frequency on the target and try to size out the target with the coil. Also say you were running in 3 tone, swap to deep and listen to what it sounds like with deep on. Another way to distinguish is you can setup a test garden with different depths like 2 nickels then 2 pull tabs and listen to what it sounds like after you wiggle swap frequencies, and modes. And turning on the target like 90 degrees.
Good luck
Reply With Quote


  #6  
Old 10-08-2020, 01:14 AM
Metal Hunting's Avatar
Metal Hunting Metal Hunting is offline
Junior Member
 
Join Date: Mar 2018
Location: At the lake
Posts: 78
Default

I hate pull tabs but you have to dig them. Pretty well the same range on any machine I've owned.
Reply With Quote


  #7  
Old 10-10-2020, 10:39 PM
MTtrashdigger MTtrashdigger is offline
Senior Member
 
Join Date: Dec 2017
Location: Montana
Posts: 449
Default

I dig a lot of nickels. I am getting better at distinguishing them from pull tabs with my Equinox. I sweep the target from at least 3 directions and wiggle the coil. If the VDI jumps above 13 or below 12 and the target is relatively shallow, I pass. If it stays solid on 12-13, and/or is deep, I dig. I still get plenty of square pull tabs and some deeper folded over beavertails, but my ratio of nickels to junk has gone up considerably. And couple of those "nickels" have turned out to be gold rings. Although I have no experience with the Anfibio, I can't believe the technique to use would be much different.

__________________
Fisher 1266X ,Minelab EQ800, Garrett Propointer II, homemade probe and Lesche hand digger, oldest coin- 1888 Indian Head Penny

Reply With Quote


  #8  
Old 10-13-2020, 01:52 PM
bunkeru2k bunkeru2k is offline
Junior Member
 
Join Date: May 2020
Posts: 34
Default

Originally Posted by MTtrashdigger View post
I dig a lot of nickels. I am getting better at distinguishing them from pull tabs with my Equinox. I sweep the target from at least 3 directions and wiggle the coil. If the VDI jumps above 13 or below 12 and the target is relatively shallow, I pass. If it stays solid on 12-13, and/or is deep, I dig. I still get plenty of square pull tabs and some deeper folded over beavertails, but my ratio of nickels to junk has gone up considerably. And couple of those "nickels" have turned out to be gold rings. Although I have no experience with the Anfibio, I can't believe the technique to use would be much different.
This x1000. With the Nox I do a full 360 wiggle on them and if it shows a 14 on it anywhere in that circle it is a guaranteed modern tab. The beavertails seem to hit a 10 or 11 when I do that circle if they are not folded and will hit more 12's than 13's if they are folded. I actually look at nickels as a measure of success when I can distinguish them from the pull tab hell.
Reply With Quote


  #9  
Old 10-13-2020, 02:21 PM
MuddyMo MuddyMo is offline
Supporter
 
Join Date: Nov 2018
Location: NW Missouri unfortunately
Posts: 1,167
Default

OMG, don't turn this into another nox thread. 😣

__________________
Best find in 45 years of detecting- A good time.

Reply With Quote


1 members found this post helpful.
  #10  
Old 10-16-2020, 01:58 AM
Akb82317's Avatar
Akb82317 Akb82317 is offline
New Member
 
Join Date: Aug 2020
Posts: 3
Default

I forgot to mention, when your re checking the target to pay attention to the ground mineralization bar. If the bar changes usually itís candles or a pull tab if it doesnít change your odds are higher if it being a nickel.
Reply With Quote


Reply


Tags
anfibio multi and coins., nickels

Thread Tools
Display Modes

Forum Jump


All times are GMT -4. The time now is 11:06 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.