bootyhound
Full Member
Is the battery plug on the excal polarity specific, in other words does it matter which prong goes into either port on the excal battery? I assume it is .. ive been tinkering inside and soldered a new coil onto the board,put every thing back together and it was then i noticed the threaded piece on the end cap snapped off under the strain relief arrrgghh! So in order to epoxy the threaded plastic piece back onto the endcap i had to disassemble the the battery plug but dont remember which wire went to which prong.... i figure ive got a 50 / 50 shot as there are only 2 wires, but if i gueess wrong what will happen? Will it simply not power up if wrong or will it fry the board... i recall a + and - wire inside so polarity must be important. ..thanks in advance. ...