Do most of you use the pre loaded coin mode?
When coinshooting what numbers do you dig?
My machine shows a silver quarter as 10-47,clad quarter is 11-46, 11-47. Is this ok? thanks!
I started out using Andy's Coin pattern and have not got away from that when running in Conductive.
When I do hunt in TTF, I either run in AM or have some discrimination at the 01 and 02 lines.
When coin shooting the CONDUCTIVE numbers tell me what/when to dig. It is hard not to look at all the numbers, but I'm mainly looking at the Conductive Numbers as I look at the depth meter.
For coppers and silvers - (34 up to 48 Conductives)
Nickels - (10-15) I will dig some others 9, 16, on occasion.
I will tell you this. I'm pretty much not going to pass up these numbers. I don't care what the depth is. Ok, OK SOMETIMES I will pass up on shallow zincolns ONLY if I've dug a few at a certain spot. I've dug up zincolns, re-scanned the hole and found wheat's 4" further down.
Don't worry about clad dime/quarter. Dig 'em up. I've had silver come in on the Conductive side from 41 all the way to 49. You CAN'T get stuck on going by the numbers. MANY worn Barbers and seateds will come in like a wheat penny at 6 inches or deeper.
#1 Rule - AUDIO ALWAYS WINS - Especially on those that hit from 2 directions (on the 90 also)
NebTrac