dumbdigger
Elite Member
- Joined
- Feb 20, 2013
- Messages
- 1,380
I know our F2's have a reset by holding in the on button. Just want to make sure I do it right. When I hold it for 10 seconds, I dont see an actual change in the screen. It doesnt flash or go clear then restart. It doesnt do anything.
Or just do you assume it reset? One of the reasons for the reset is I noticed the last few hunts I went on the ID #s are one or two higher than in the past. So a quarter that came up 83-84, now comes in 84-85. Now the only time it has come in as 84-85 in the past, is when it is a state quarter or a silver quarter. Yes, I know it is most likely a state quarter before I dig.
Anyhow, I thought by resetting you would see a conformation on the screen.
THANKS DD
Or just do you assume it reset? One of the reasons for the reset is I noticed the last few hunts I went on the ID #s are one or two higher than in the past. So a quarter that came up 83-84, now comes in 84-85. Now the only time it has come in as 84-85 in the past, is when it is a state quarter or a silver quarter. Yes, I know it is most likely a state quarter before I dig.
Anyhow, I thought by resetting you would see a conformation on the screen.
THANKS DD