Saoirse
Forum Supporter
- Joined
- Sep 10, 2016
- Messages
- 1,603
What you need - A file, 22mm rubber chair leg protector or similar, craft knife, electrical tape (Optional)
I've had this on my pointer since day one and it works very well (The cat took a fancy to the old one so I took a few photos when replacing it)
Some minor modification involved, I used a file to remove about 20mm from the bottom of the scraper blade and filed it down until flush, the rubber protector won't sit flush otherwise.
You can leave it as is in the middle photo as the fit is tight already.
I trimmed some of the excess rubber away with a sharp knife as it's awkward sliding in and out of the holster (If you find it tight insert the pointer into the bottom of the holster and wiggle it around until you stretch it out a bit)
I've had this on my pointer since day one and it works very well (The cat took a fancy to the old one so I took a few photos when replacing it)
Some minor modification involved, I used a file to remove about 20mm from the bottom of the scraper blade and filed it down until flush, the rubber protector won't sit flush otherwise.
You can leave it as is in the middle photo as the fit is tight already.
I trimmed some of the excess rubber away with a sharp knife as it's awkward sliding in and out of the holster (If you find it tight insert the pointer into the bottom of the holster and wiggle it around until you stretch it out a bit)
