ToddB64
Elite Member
I have a new Ace250, purchased last December,
2005.
My question is as follows:
When I am detecting in All-Metal mode and the machine signals a target at 6" depth, I swing the coil to the side, hold down the Pinpoint button
and swing the coil slowly back over the target
area until both the audio response reaches max.
and the visual black-bar indicators reach the far-
right side of the console screen and I know I'm
right over the target. At this point the depth
reading has changed to 2".
My understanding is that when I switch to
Pinpoint mode, it is the same as being in All-Metal
or it's equivalent. So, if these two modes are the same, why does my machine report a
shallower depth in Pinpoint mode ?
Anyone out there know the answer to this ?
Thanks for your help.
ToddB64
Ace250
2005.
My question is as follows:
When I am detecting in All-Metal mode and the machine signals a target at 6" depth, I swing the coil to the side, hold down the Pinpoint button
and swing the coil slowly back over the target
area until both the audio response reaches max.
and the visual black-bar indicators reach the far-
right side of the console screen and I know I'm
right over the target. At this point the depth
reading has changed to 2".
My understanding is that when I switch to
Pinpoint mode, it is the same as being in All-Metal
or it's equivalent. So, if these two modes are the same, why does my machine report a
shallower depth in Pinpoint mode ?
Anyone out there know the answer to this ?
Thanks for your help.
ToddB64
Ace250