I broke my 800 cuff while still under warranty, was promptly sent a new one but wondered if I could repair the old one with my recently purchased 3d printer. What I came up with seems to work well with the break on the side. I've been using the repaired one but also put them on the new one as preventative and keep it along as backup. I only have about 10hrs on the repaired cuff but so far so good. Also printed ear stiffeners for the nox 15" coil as preventative, they were not broken yet, so far so good on those too and I've been banging the hell out it. Will see how they all hold up in the long term. Will report back if they fail. All printed with petg filament.
Nox cuff repair
- Thread starter Drew61
- Start date
cellrdwellr
Elite Member
Nice work, looking forward to the updates after use. Thanks for sharing!
lords20
Senior Member
May i please have a copy of the stl files for printing them?
Silversmith45
Elite Member
What sort of glue did you use to fasten the parts on with?
choppadude
Forum Supporter
Nice work. Love the coil ear stiffners.
hoser
Forum Supporter
Very well done. I'm impressed at what you can do with a 3D printer these days.
So far the two sets of parts are holding up well. Am still using the repaired arm cuff exclusively. I occasionally switch coils but don't expect any issues with the reinforced tabs. Appreciate the positive comments!
