sullivan2002
New Member
- Joined
- Feb 8, 2019
- Messages
- 5
Hi to all diggers
I need to repair my Excalibur the schematic diagram. My Excalibur is 1000 with 8" Coil, but if you have the new Excalibur It could be ok maybe.
Is there anyone who has it? to share me please
Problem of my Excalibur could be:
1. Coil (but my coil is like new) always I washed at home after any use on the sea
2. Cable (I think is ok, I never twisted on the shaft on the advice of who sold it to me)
3. Potenziometer (Disc/Pin - Threshold - Volume) the others I think are ok for sure for many reasons. Not sure if 10Kohm or 100Kohm but I read on the net that is 39SA-1RB-103-ND with the cut on it.
https://www.digikey.com/product-detail/en/bourns-inc/39SA-1RB-103/39SA-1RB-103-ND/954395
4. Quartz (I think 3.904Mhz, I don't think it's Khz)
5. Microprocessor I hope it's not due to the fact that temperatures are not high inside
6. Board
7. oxidations water humidity and condensation on the boards (I don't think so, boards are very clean and no oxidation I see on boards
These are videos I made:
https://www.youtube.com/watch?v=l5_KrrTV9Dg
https://www.youtube.com/watch?v=o32VoqV-2js
https://www.youtube.com/watch?v=jSZbrB0pxjs
Could you help me?
I need the schematic diagram of the circuit of the Excalibur 1000
need to know where to find the exact potenziometer of Threshold and if it's really 10Kohm or 100Kohm
THANKS A LOT IN ADVANCE
I need to repair my Excalibur the schematic diagram. My Excalibur is 1000 with 8" Coil, but if you have the new Excalibur It could be ok maybe.
Is there anyone who has it? to share me please
Problem of my Excalibur could be:
1. Coil (but my coil is like new) always I washed at home after any use on the sea
2. Cable (I think is ok, I never twisted on the shaft on the advice of who sold it to me)
3. Potenziometer (Disc/Pin - Threshold - Volume) the others I think are ok for sure for many reasons. Not sure if 10Kohm or 100Kohm but I read on the net that is 39SA-1RB-103-ND with the cut on it.
https://www.digikey.com/product-detail/en/bourns-inc/39SA-1RB-103/39SA-1RB-103-ND/954395
4. Quartz (I think 3.904Mhz, I don't think it's Khz)
5. Microprocessor I hope it's not due to the fact that temperatures are not high inside
6. Board
7. oxidations water humidity and condensation on the boards (I don't think so, boards are very clean and no oxidation I see on boards
These are videos I made:
https://www.youtube.com/watch?v=l5_KrrTV9Dg
https://www.youtube.com/watch?v=o32VoqV-2js
https://www.youtube.com/watch?v=jSZbrB0pxjs
Could you help me?
I need the schematic diagram of the circuit of the Excalibur 1000
need to know where to find the exact potenziometer of Threshold and if it's really 10Kohm or 100Kohm
THANKS A LOT IN ADVANCE
Last edited: