Swing4TheRing
Forum Supporter
I went to go hunt with my Excal II yesterday and when I turned it on, the threshold was humming as normal, but when I went to test a target over the coil as I always do, NOTHING! No sound or response even when I swing my wedding band right over the coil only an inch away.
I checked all my settings to make sure volume is up, discrimination is only at 1, so all is normal there, but I just get NO response for a signal! Any help or advice?
I charged the battery overnight and just tried it again, but same air test with targets failed - no response from detector.
Thoughts? Thanks for the help!
I checked all my settings to make sure volume is up, discrimination is only at 1, so all is normal there, but I just get NO response for a signal! Any help or advice?
I charged the battery overnight and just tried it again, but same air test with targets failed - no response from detector.
Thoughts? Thanks for the help!