Has anyone noticed a delay in VID readings when going from one target to another that's in close proximity?
Fast on or off does not seem to make a difference, maybe this is normal??
Example: laying out say 4 coins the VID responds and is correct over the first one, if you move directly to the second coin the VID remains unchanged until you lift the coil away from then return to the target coin. Then the VID will change and read correctly over the second coin.
If you were to move directly to the third coin the VID would not change until the coil was lifted away from the third coin but then when lowered back would indicate the correct third coin reading.
Coins 8-10 inches apart
Same on any coil used, did a factory reset, same thing. ???
Fast on or off does not seem to make a difference, maybe this is normal??
Example: laying out say 4 coins the VID responds and is correct over the first one, if you move directly to the second coin the VID remains unchanged until you lift the coil away from then return to the target coin. Then the VID will change and read correctly over the second coin.
If you were to move directly to the third coin the VID would not change until the coil was lifted away from the third coin but then when lowered back would indicate the correct third coin reading.
Coins 8-10 inches apart
Same on any coil used, did a factory reset, same thing. ???