Do you all use any thing to help seal the connections on the ATP? I change the batteries a bit and am going to be getting it wet shortly and want to know if I should us a silicone sealant or something else?? Thanks in advance! GL & HH!!
ATPro Seal Question
- Thread starter TheStelt
- Start date
Brainworm
Elite Member
Plumbers grease contains silicone and works well.
Big Boys Hobbies
Forum Sponsor
It has a very slight bit from factory so you should be good for awhile.
Power Guy
Senior Member
I would say any type of grease or silicone would be fine. (just stay away petroleum based products) they will eat the rubber seals over time
Crackerjack
Elite Member
Here is a link to a web page that discusses seal lubes very well.
http://www.candlepowerforums.com/vb/showthread.php?126645-Comprehensive-Grease-and-Lube-Thread
Firstring
Senior Member
As Irons says, dielectric compound. It can be purchased in small quantities, is inexpensive and can be found at most any auto parts store. A little bit goes a long way. Don't forget a bit around the o ring at battery door.
