chukarhunt
New Member
- Joined
- Nov 15, 2017
- Messages
- 12
Hey everybody,
Just used my 3D printer to make a cover for the base. Not sure if it was totally necessary, but do you think it would interfere with the coils/signal? I know it is just plastic, so probably not, but didn’t know if anybody had any experience with this. Figured it might make a good guard when out working with the detector too. Thanks in advance!
Just used my 3D printer to make a cover for the base. Not sure if it was totally necessary, but do you think it would interfere with the coils/signal? I know it is just plastic, so probably not, but didn’t know if anybody had any experience with this. Figured it might make a good guard when out working with the detector too. Thanks in advance!