zeemang
Forum Supporter
Anyway, my excal has started having a senior moments again. It is probably about ten years old now and used hard and I have managed to repair everything myself until now. Changed headphones, changed coil, etc, not new to opening these up to have a look.
In disc it is just super chattery to the point you can not distinguish between a signal and the rest of it, and in pinpoint it just screams at you. Upon opening it up there was some noticable water damage on the lower board. I am not sure if the circuit is printed on the green stuff that has flaked off or actually inside the board. On a scale of repair-ability am I looking at a "Sure you can fix that" or a "Well, it's been a good machine, time to leave it for dead?"
Thanks!
Attachments
Last edited: