View Single Post
  #151  
Old 05-10-2015, 02:05 PM
Gatchaman's Avatar
Gatchaman Gatchaman is offline
Senior Member
 
Join Date: Nov 2012
Location: Virginia
Posts: 286
Default

Gain ~1/4" mod.

Remove the end cap buy getting a thin blade and slowly prying upwards going all the way around. Eventually it will come off.

Once off, you will see about a 1/4" gap (could be more, depends on where it was set) from the end of the rod inside to the end of the pvc.

Measure the depth and mark it along the outside of the pvc. Trim it down with a saw to where the rod is now flush with the pvc. Now trim the cap the same amount (it is plenty long), remove the craft glue from inside then put it back on.

__________________
Fisher F2 / Home-made surf-PI / BH Tracker IV, Vibra-Tector 730

Reply With Quote


2 members found this post helpful.