Seaking406
Elite Member
Greetings again. After a lot of successful hole digging in the past few days, I'm noticing that the device's pin pointing accuracy might be off, or am I interpreting it wrongly!?
When I find a target, I press the PP button and move the coil over the target until I get a full signal... But when looking down at the coil, exactly which part of the coil is the target sitting exactly under? So far I've seen it being either in front or behind the attachment bolt, or slightly to the side of it.. close but not quite precise... Pushing the Carrot against the soil shows me where it is under the sod and it's usually not quite where I would think it should be from what I have read and seen in tutorials...
Is there something I might be missing or not understanding about this process? Any help or advice would be greatly appreciated.
Thanks!
When I find a target, I press the PP button and move the coil over the target until I get a full signal... But when looking down at the coil, exactly which part of the coil is the target sitting exactly under? So far I've seen it being either in front or behind the attachment bolt, or slightly to the side of it.. close but not quite precise... Pushing the Carrot against the soil shows me where it is under the sod and it's usually not quite where I would think it should be from what I have read and seen in tutorials...
Is there something I might be missing or not understanding about this process? Any help or advice would be greatly appreciated.
Thanks!